Table list used by SAP ABAP Program LEG72F10 (Check and Copy of Parameters)
SAP ABAP Program LEG72F10 (Check and Copy of Parameters) is using
# Object Type Object Name Object Description Note
     
1 Table  DCOBJDEF Name of a DDIC object with status
2 Table  DD07V Generated Table for View
3 Table  EDEVGR Master Data for Device Group
4 Table  EMSG_MSG Int. Structure for Macros
5 Table  ETDZ Technical Data for Installed Register
6 Table  ETYP Dev. Cat.: IS-U Additional Material Data
7 Table  EWIK Winding Group
8 Table  ISU00_OBJ_CONTR Control Data for IS-U Objects
9 Table  ISU07_CUSTOMIZE Customizing Data for Inst./Removal/Repl./Inst. Structure
10 Table  ISU07_EGER V_EGER for I/R/R
11 Table  ISU07_EGERKEY Block key for Equipment
12 Table  ISU07_INSTALL_STRUC Category Definition for Entire Installation Structure
13 Table  ISU07_REGISTER_FACTOR Registers with Transformation Ratio and Billing Factor
14 Table  ISU07_TRANS_WINDING Transformer Windings for Interface ISU_BILLING_FACTOR_DETERM
15 Table  ISU_ZWFAKT Factors in Register
16 Table  REG72_D Screen Fields for Dev. Alloc. at Device Level
17 Table  REG72_R Screen Fields for Dev. Alloc. at Register level
18 Table  REGEN General Fields for IS-U Function Module Interfaces
19 Table  TE100 Controls for Device Installation/Removal/Replacement
20 Table  TE373 Command/Programming
21 Table  TE593 Types of Device Group
22 Table  TESPT Alloc. of Div. Cat. to Div.
23 Table  V_EGER Generated Table for View
24 Table  V_EZUA Generated Table for View